UBC Undergraduate Research

Role of Dolomite Content on the Mechanical Strength and Failure-Mechanisms in Dolomite-Limestone Composites Cleven, Nathan R.

Abstract

Variably dolomitized limestone samples from the Rundle Group in Western Alberta, Canada were deformed under a variety of confining pressures and at room temperature in a triaxial rock press. The aim of this research is to establish the mechanical behaviour and brittle constitutive laws of limestone and dolomite composites. This data can then be used to develop strength profiles of thrust faults in the Rocky Mountain Fold and Thrust Belt. For example, many of the thrust faults in the Canadian Foreland are composed of limestone–dolomite composites, yet the mechanical properties of these composites remain unknown. Sample protoliths were selected for their similar grain sizes and grain size distributions, low porosity and low silica content in order to best examine relationships between these parameters and the distribution of strain between the dolomite and calcite. This study shows that increasing dolomite content correlates to an increase in strength at low and medium confining pressures. At high confining pressures, distributed brittle deformation adds complexities that are attributed to textural controls. Microstructural analysis of deformed samples shows that at approximately thirty to forty-five weight percent dolomite is interconnected via a dolomite grain network that provides a load-bearing capacity to the dolomite. This load-bearing capacity correlates to dramatic jumps in the strength of dolomite–limestone composites observed with increasing confining pressures. Inherent weaknesses in calcite grains such as twin planes and cleavage intersections are exploited by fractures resulting in reduced peak strengths of calcite-rich composites. Calcite generally absorbs strain and distributes it into finer spaced fracture networks than in dolomite. In dolomitized rock that still contains calcite cleavage within dolomite is not exploited, rather transgranular cracks break dolomite down into irregular and angular particles. At near pure dolomite content and at high confining pressure dolomite will fracture and disaggregate along cleavage. Comminuted dolomite grains commonly show a larger distribution of sizes and have more irregular shapes than contiguous comminuted calcite grains. Comminuted calcite particles are commonly much smaller than comminuted dolomite grains and show more regular shapes and an even grain size distribution.

Item Citations and Data

Rights

Attribution-NonCommercial-NoDerivatives 4.0 International