Go to  Advanced Search

Please note that cIRcle is currently being upgraded to DSpace v5.1. The upgrade means that the cIRcle service will *not* be accepting new submissions from 5:00 PM on September 1, 2015 until 5:00 PM on September 4, 2015. All cIRcle material will still be accessible during this period. Apologies for any inconvenience. [CYPRESS]

The damping of surface water waves in containers with grooved surfaces

Show simple item record

dc.contributor.author Gettel, Lorne Edward
dc.date.accessioned 2010-01-29T20:43:44Z
dc.date.available 2010-01-29T20:43:44Z
dc.date.copyright 1975 en
dc.date.issued 2010-01-29T20:43:44Z
dc.identifier.uri http://hdl.handle.net/2429/19365
dc.description.abstract The damping, of surface waves on shallow water can be affected by the roughness of the container walls as well as by surfactant layers present on the air-water interface. The increase in the damping caused by a grooved wave tank base has been studied both theoretically and experimentally. In any experimental investigation into the effect of surface roughness on the damping, surfactants can obscure the effects of wall roughness. An experimental technique is described to enable the relative importance of these two effects to be determined unambiguously. Initially experiments were conducted with the groove amplitude much smaller than the viscous boundary layer thickness. It was found that the increase in the damping caused by the grooved base was small (< 5% increase). The damping has also been studied for large amplitude grooves on the base of the wave tank (dimensions much larger than the viscous boundary layer thickness). It is shown theoretically that, for grooves of triangular or approximately sinusoidal cross section, the damping is increased by an amount proportional to the total surface area of the grooved surface, and is independent of the direction of flow with respect to the grooves. The theoretical model applies when the groove spacing and amplitude are small compared to the fluid depth and wavelength of the surface waves, but are large compared to the viscous boundary layer thickness. Experiments were conducted to test these predictions. By carrying out observations on two surface modes, it is shown that the observed increased damping is due to the grooved surface alone and cannot be attributed to spurious surfactant effects. It was found experimentally that the damping was independent of flow direction with respect to the grooves, and the increase in the damping was strictly proportional to the fractional increase in the area of the base, in complete agreement with the theoretical predictions. en
dc.language.iso eng en
dc.relation.ispartof Retrospective Theses and Dissertations, 1919-2007 en
dc.relation.ispartofseries UBC Retrospective Theses Digitization Project [http://www.library.ubc.ca/archives/retro_theses/]
dc.title The damping of surface water waves in containers with grooved surfaces en
dc.type Text
dc.degree.name Master of Science - MSc en
dc.degree.discipline Physics en
dc.degree.grantor University of British Columbia
dc.type.text Thesis/Dissertation en
dc.description.affiliation Science, Faculty of en
dc.degree.campus UBCV en
dc.description.scholarlevel Graduate en

Files in this item

Files Size Format Description   View
UBC_1975_A6_7 G04.pdf 7.609Mb Adobe Portable Document Format   View/Open

This item appears in the following Collection(s)

Show simple item record

UBC Library
1961 East Mall
Vancouver, B.C.
Canada V6T 1Z1
Tel: 604-822-6375
Fax: 604-822-3893