Go to  Advanced Search

The ultimate load capacity of square shear plates with circular perforations : (parameter study)

Show full item record

Files in this item

Files Size Format Description   View
UBC_1985_A7 M37_7.pdf 7.890Mb Adobe Portable Document Format   View/Open
Title: The ultimate load capacity of square shear plates with circular perforations : (parameter study)
Author: Martin, Anthony George
Degree: Master of Applied Science - MASc
Program: Civil Engineering
Copyright Date: 1985
Subject Keywords Plates (Engineering) - Testing
Issue Date: 2010-05-28
Publisher University of British Columbia
Series/Report no. UBC Retrospective Theses Digitization Project [http://www.library.ubc.ca/archives/retro_theses/]
Abstract: The incremental structural analysis program NISA83 was used to investigate various parameters affecting the ultimate capacity of square plates with circular perforations subjected to uniform shear stress. Both nonlinear material properties and nonlinear geometry were taken into account in determining the ultimate in-plane capacities and buckling capacities of perforated shear plates. The parameters investigated during this study were the hole size for a concentric location, and the hole location for a constant ratio of hole diameter to plate width of 0.2. In addition various doubler plates were studied to determine the most effective shape to restore a shear plate to its original ultimate in-plane capacity. For the first two parameters, the analysis was separated into three parts. The ultimate in-plane capacity, elastic buckling capacity and the ultimate elastic-plastic buckling capacity was determined for each combination of the two parameters. These were used to identify the importance of both elastic buckling and nonlinear material contribute to the reduced ultimate plate capacities. The results from plates with a concentrically located hole of varying size showed excellent correlation with other published experimental and analytical results for both the in-plane capacity and the 3-dimensional buckling capacities. Variation of the center location of a hole of a standard size provided some significant results. Little change was found in the ultimate in-plane capacity for all hole locations. On the other hand, the elastic buckling capacity was raised by 50% after moving the hole from the plate tension diagonal to the compression diagonal. Finally, from the ultimate elastic-plastic' buckling capacity results it was concluded that the concentric provides lower bound capacity for all other hole locations. The in-plane analysis of the optimum doubler plate size showed wide and thin plates to be more effective than narrow and thick plates. A doubler plate with the same thickness as the plate and twice the diameter of the hole is recommended to restore the perforated plate to its original in-plane capacity. In order to aid in the tedious task of checking the input data and to provide a convenient way of displaying the result, a full graphic post-processor was developed as part of this thesis. The program NISPLOT used color graphics available at the UBC Civil Engineering lab to process the output from NISA83. It was written in FORTRAN 77, utilizing subroutines from a commercial graphics package, DI3000, to obtain device independent graphics. NISPLOT generated plots of the nodes and element mesh for each data check. When a complete analysis was carried out by NISA83, nodes, element mesh, deflected shape, and color stress fill plots were generated.
Affiliation: Applied Science, Faculty of
URI: http://hdl.handle.net/2429/25119
Scholarly Level: Graduate

This item appears in the following Collection(s)

Show full item record

UBC Library
1961 East Mall
Vancouver, B.C.
Canada V6T 1Z1
Tel: 604-822-6375
Fax: 604-822-3893